Effect of machining the load capacity notched components

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F44555601%3A13420%2F14%3A43886257" target="_blank" >RIV/44555601:13420/14:43886257 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Effect of machining the load capacity notched components

Popis výsledku v původním jazyce

Nowadays is issue investigation the notch problems and their influence on component durability. For many manufactured components, we find various types of notches, such as grooves, step and holes. They have a tend to be the place where is concentrated stress, so called the macroscopic stress concentrator. In this area is higher risk of part destruction. Nowadays, there are hypotheses that are based on the assumption that the higher the roughness, the lower the durability. In many cases the designers prescribe unnecessarily high surface quality. It is necessary to maintain adequate quality of the surface, and also necessary that the component has attained a high durability. The paper deals with the influence of machining technology carrying capacity ofnotched components. As the test material was used steel Fe510 according to EN ISO (11523, according to CSN 42 0002).

Název v anglickém jazyce

Effect of machining the load capacity notched components

Popis výsledku anglicky

Nowadays is issue investigation the notch problems and their influence on component durability. For many manufactured components, we find various types of notches, such as grooves, step and holes. They have a tend to be the place where is concentrated stress, so called the macroscopic stress concentrator. In this area is higher risk of part destruction. Nowadays, there are hypotheses that are based on the assumption that the higher the roughness, the lower the durability. In many cases the designers prescribe unnecessarily high surface quality. It is necessary to maintain adequate quality of the surface, and also necessary that the component has attained a high durability. The paper deals with the influence of machining technology carrying capacity ofnotched components. As the test material was used steel Fe510 according to EN ISO (11523, according to CSN 42 0002).

Druh

J_x - Nezařazeno - Článek v odborném periodiku (Jimp, Jsc a Jost)

CEP obor

JL - Únava materiálu a lomová mechanika

OECD FORD obor

—

Projekt

<a href="/cs/project/GA101%2F09%2F0504" target="_blank" >GA101/09/0504: Výzkum vlivu dokončovacích a progresivních metod obrábění na funkční vlastnosti konstrukčních vrubů z hlediska možných katastrofických důsledků</a><br>

Návaznosti

P - Projekt vyzkumu a vyvoje financovany z verejnych zdroju (s odkazem do CEP)

Rok uplatnění

2014

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Manufacturing Technology

ISSN

1213-2489

e-ISSN

—

Svazek periodika

14

Číslo periodika v rámci svazku

1

Stát vydavatele periodika

CZ - Česká republika

Počet stran výsledku

4

Strana od-do

47-50

Kód UT WoS článku

—

EID výsledku v databázi Scopus

—