Effect of machining technology for durability with notched components

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F44555601%3A13420%2F16%3A43887968" target="_blank" >RIV/44555601:13420/16:43887968 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Effect of machining technology for durability with notched components

Popis výsledku v původním jazyce

Nowadays, the notch problems and their influence on component durability are the issue of investigation. For many manufactured components, we find various types of notches, such as grooves, step and holes. They have a tendency to be in the place where stress is concentrated, the so called macroscopic stress concentrator. This area is a dangerous part of a component. Nowadays, there are hypotheses that are based on the assumption that the higher the roughness, the lower the durability. In many cases the designers prescribe unnecessarily high surface quality. It is necessary to maintain adequate quality of the surface, and also it is necessary that the component has attained a high durability. The paper deals with the influence of machining technology carrying capacity of notched components. As the test material steel Fe510 was used according to EN ISO (11523, according to CSN 42 0002).

Název v anglickém jazyce

Effect of machining technology for durability with notched components

Popis výsledku anglicky

Nowadays, the notch problems and their influence on component durability are the issue of investigation. For many manufactured components, we find various types of notches, such as grooves, step and holes. They have a tendency to be in the place where stress is concentrated, the so called macroscopic stress concentrator. This area is a dangerous part of a component. Nowadays, there are hypotheses that are based on the assumption that the higher the roughness, the lower the durability. In many cases the designers prescribe unnecessarily high surface quality. It is necessary to maintain adequate quality of the surface, and also it is necessary that the component has attained a high durability. The paper deals with the influence of machining technology carrying capacity of notched components. As the test material steel Fe510 was used according to EN ISO (11523, according to CSN 42 0002).

Druh

D - Stať ve sborníku

CEP obor

JL - Únava materiálu a lomová mechanika

OECD FORD obor

—

Projekt

—

Návaznosti

I - Institucionalni podpora na dlouhodoby koncepcni rozvoj vyzkumne organizace

Rok uplatnění

2016

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název statě ve sborníku

Engineering for Rural Development

ISBN

—

ISSN

1691-3043

e-ISSN

—

Počet stran výsledku

6

Strana od-do

800-805

Název nakladatele

Latvia University of Agriculture Faculty of Engineering

Místo vydání

Jelgava

Místo konání akce

Jelgava, Latvia

Datum konání akce

25. 5. 2016

Typ akce podle státní příslušnosti

WRD - Celosvětová akce

Kód UT WoS článku

000390059500124