The impact of changes in infeed rate on surface integrity after chrome plate grinding by silicon carbide

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F44555601%3A13420%2F19%3A43894976" target="_blank" >RIV/44555601:13420/19:43894976 - isvavai.cz</a>

Výsledek na webu

<a href="https://arl.ujep.cz/arl-ujep/en/csg/?repo=ujeprepo&key=22115050539" target="_blank" >https://arl.ujep.cz/arl-ujep/en/csg/?repo=ujeprepo&key=22115050539</a>

DOI - Digital Object Identifier

<a href="http://dx.doi.org/10.21062/ujep/284.2019/a/1213-2489/mt/19/2/284" target="_blank" >10.21062/ujep/284.2019/a/1213-2489/mt/19/2/284</a>

Jazyk výsledku

angličtina

Název v původním jazyce

The impact of changes in infeed rate on surface integrity after chrome plate grinding by silicon carbide

Popis výsledku v původním jazyce

Grinding is a significant and very commonly used technology, allowing for important gains in surface integrity. The surface integrity quality after grinding is one of the most important parameters, which is prescribed on the production drawing. Chrome plating as protection against corrosion, erosion, abrasion and as a material for the overhaul of worn-out parts is used. This paper discusses the change of cutting conditions when samples were ground. The surface of all samples was preserved with galvanically applied chrome. The values show which grade of surface roughness is attained when selecting different cutting conditions. The results of surface integrity after grinding were evaluated depending on the comparison of the parameters of roughness. The input parameters of cutting conditions were chosen based on the experience, which was implemented.

Název v anglickém jazyce

The impact of changes in infeed rate on surface integrity after chrome plate grinding by silicon carbide

Popis výsledku anglicky

Grinding is a significant and very commonly used technology, allowing for important gains in surface integrity. The surface integrity quality after grinding is one of the most important parameters, which is prescribed on the production drawing. Chrome plating as protection against corrosion, erosion, abrasion and as a material for the overhaul of worn-out parts is used. This paper discusses the change of cutting conditions when samples were ground. The surface of all samples was preserved with galvanically applied chrome. The values show which grade of surface roughness is attained when selecting different cutting conditions. The results of surface integrity after grinding were evaluated depending on the comparison of the parameters of roughness. The input parameters of cutting conditions were chosen based on the experience, which was implemented.

Druh

J_SC - Článek v periodiku v databázi SCOPUS

CEP obor

—

OECD FORD obor

20301 - Mechanical engineering

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2019

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Manufacturing Technology

ISSN

1213-2489

e-ISSN

—

Svazek periodika

19

Číslo periodika v rámci svazku

2

Stát vydavatele periodika

CZ - Česká republika

Počet stran výsledku

8

Strana od-do

284-291

Kód UT WoS článku

—

EID výsledku v databázi Scopus

2-s2.0-85065410730