Study of plughing forces on the flank face of cutting tools

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F46747885%3A24210%2F14%3A00003358" target="_blank" >RIV/46747885:24210/14:00003358 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Study of plughing forces on the flank face of cutting tools

Popis výsledku v původním jazyce

Determination of the ploughing forces is necessary for monitoring the wear of the cutting tool in micro-cutting. The aim of this research was to increase the accuracy of determining the ploughing force, the determination of the uncut chip thickness influence on the ploughing force, study of reasons for increased active force using coolant with uncut chip thickness. A new method for determining the ploughing forces is suggested in this book. It was found that the ploughing forces determined by the new method were greater than those determined by the method comparing total forces at different flank levels of wear. It was first established that the uncut chip thickness influences the ploughing force. This publication has been prepared within the project "TECHNOMAT" (reg. No. CZ.1.07/2.2.00/28.0316) which was financed by the European Social Fund and the Czech Republic budget.

Název v anglickém jazyce

Study of plughing forces on the flank face of cutting tools

Popis výsledku anglicky

Determination of the ploughing forces is necessary for monitoring the wear of the cutting tool in micro-cutting. The aim of this research was to increase the accuracy of determining the ploughing force, the determination of the uncut chip thickness influence on the ploughing force, study of reasons for increased active force using coolant with uncut chip thickness. A new method for determining the ploughing forces is suggested in this book. It was found that the ploughing forces determined by the new method were greater than those determined by the method comparing total forces at different flank levels of wear. It was first established that the uncut chip thickness influences the ploughing force. This publication has been prepared within the project "TECHNOMAT" (reg. No. CZ.1.07/2.2.00/28.0316) which was financed by the European Social Fund and the Czech Republic budget.

Druh

O - Ostatní výsledky

CEP obor

JR - Ostatní strojírenství

OECD FORD obor

—

Projekt

—

Návaznosti

O - Projekt operacniho programu

Rok uplatnění

2014

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů