Increasing the accuracy of the effect of processing materials and cutting tool wear on the ploughing force values

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F46747885%3A24210%2F13%3A%230005718" target="_blank" >RIV/46747885:24210/13:#0005718 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Increasing the accuracy of the effect of processing materials and cutting tool wear on the ploughing force values

Popis výsledku v původním jazyce

The determination of the ploughing forces is necessary for wear monitoring of the cutting tool in micro cutting. The extrapolation method on zero cut chip thickness is used very often to determine the ploughing forces. But there are many opponents of theextrapolation method on zero uncut thickness. The aim of this research was to increase the accuracy of determination of the ploughing force and to investigate the effect of processing materials and cutting tool wear on the ploughing force values. To achieve this aim was used the method comparing total forces at different flank levels of wear to determine the ploughing forces. The experiments were performed by cutting of aluminum alloys, structural steels and stainless steel with different cutting toolwear.

Název v anglickém jazyce

Increasing the accuracy of the effect of processing materials and cutting tool wear on the ploughing force values

Popis výsledku anglicky

The determination of the ploughing forces is necessary for wear monitoring of the cutting tool in micro cutting. The extrapolation method on zero cut chip thickness is used very often to determine the ploughing forces. But there are many opponents of theextrapolation method on zero uncut thickness. The aim of this research was to increase the accuracy of determination of the ploughing force and to investigate the effect of processing materials and cutting tool wear on the ploughing force values. To achieve this aim was used the method comparing total forces at different flank levels of wear to determine the ploughing forces. The experiments were performed by cutting of aluminum alloys, structural steels and stainless steel with different cutting toolwear.

Druh

J_x - Nezařazeno - Článek v odborném periodiku (Jimp, Jsc a Jost)

CEP obor

JR - Ostatní strojírenství

OECD FORD obor

—

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2013

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Manufacturing Technology

ISSN

1213-2489

e-ISSN

—

Svazek periodika

13

Číslo periodika v rámci svazku

2

Stát vydavatele periodika

CZ - Česká republika

Počet stran výsledku

5

Strana od-do

169-173

Kód UT WoS článku

—

EID výsledku v databázi Scopus

—