A comparison of experimental estimation methods of the ploughing force in orthogonal cutting

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F46747885%3A24210%2F13%3A%230005716" target="_blank" >RIV/46747885:24210/13:#0005716 - isvavai.cz</a>

Výsledek na webu

<a href="http://dx.doi.org/10.1016/j.ijmachtools.2012.09.003" target="_blank" >http://dx.doi.org/10.1016/j.ijmachtools.2012.09.003</a>

DOI - Digital Object Identifier

<a href="http://dx.doi.org/10.1016/j.ijmachtools.2012.09.003" target="_blank" >10.1016/j.ijmachtools.2012.09.003</a>

Jazyk výsledku

angličtina

Název v původním jazyce

A comparison of experimental estimation methods of the ploughing force in orthogonal cutting

Popis výsledku v původním jazyce

In micro-cutting, the determination of the ploughing forces is necessary for wear monitoring of the cutting tool. The aim of this research was to confirm that the extrapolation method on zero thickness cannot be used to determine the ploughing forces. This paper presents experimental measurement results of the ploughing forces in orthogonal cutting, obtained by different methods. The comparison of measurement results was carried out in chipping of aluminium alloys and using structural and stainless steels. It was found that the ploughing forces determined by the extrapolation method on zero thickness proved to be substantially greater than those determined by the comparison method of total forces at different flank wears.

Název v anglickém jazyce

A comparison of experimental estimation methods of the ploughing force in orthogonal cutting

Popis výsledku anglicky

In micro-cutting, the determination of the ploughing forces is necessary for wear monitoring of the cutting tool. The aim of this research was to confirm that the extrapolation method on zero thickness cannot be used to determine the ploughing forces. This paper presents experimental measurement results of the ploughing forces in orthogonal cutting, obtained by different methods. The comparison of measurement results was carried out in chipping of aluminium alloys and using structural and stainless steels. It was found that the ploughing forces determined by the extrapolation method on zero thickness proved to be substantially greater than those determined by the comparison method of total forces at different flank wears.

Druh

J_x - Nezařazeno - Článek v odborném periodiku (Jimp, Jsc a Jost)

CEP obor

JR - Ostatní strojírenství

OECD FORD obor

—

Projekt

—

Návaznosti

Z - Vyzkumny zamer (s odkazem do CEZ)

Rok uplatnění

2013

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

International Journal of Machine Tools and Manufacture

ISSN

0890-6955

e-ISSN

—

Svazek periodika

65

Číslo periodika v rámci svazku

February 2013

Stát vydavatele periodika

GB - Spojené království Velké Británie a Severního Irska

Počet stran výsledku

4

Strana od-do

37-40

Kód UT WoS článku

000313849900006

EID výsledku v databázi Scopus

—