The Application of Liquid CO2 into the Die Casting Mould Tempering System

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F46747885%3A24210%2F15%3A00002389" target="_blank" >RIV/46747885:24210/15:00002389 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

The Application of Liquid CO2 into the Die Casting Mould Tempering System

Popis výsledku v původním jazyce

Optimal temperature conditions of pressure casting mold in the course of the casting cycle ensures tempering system. This allows preheat the pressure casting mold to operating temperature prior to start up and maintain the thermal balance between the casting and the mold in the course of casting. The basic part of the mold tempering system consists of interconnected canals predominantly parallel to the parting plane, through which the tempering medium flows. Today commonly used tempering systems in which tempering medium is water or oil are not sufficient for heat removing from complex shapes and thin sections of molds. This leads to overheating molds at these locations, which is the cause of porosity in certain locations of the castings and shorteningthe life of the molds. That is why finding new ways of cooling of these critical spots. This article deals with monitoring the cooling effect of the liquid CO2, which was used as a supplement to the standard tempering system in die casti

Název v anglickém jazyce

The Application of Liquid CO2 into the Die Casting Mould Tempering System

Popis výsledku anglicky

Optimal temperature conditions of pressure casting mold in the course of the casting cycle ensures tempering system. This allows preheat the pressure casting mold to operating temperature prior to start up and maintain the thermal balance between the casting and the mold in the course of casting. The basic part of the mold tempering system consists of interconnected canals predominantly parallel to the parting plane, through which the tempering medium flows. Today commonly used tempering systems in which tempering medium is water or oil are not sufficient for heat removing from complex shapes and thin sections of molds. This leads to overheating molds at these locations, which is the cause of porosity in certain locations of the castings and shorteningthe life of the molds. That is why finding new ways of cooling of these critical spots. This article deals with monitoring the cooling effect of the liquid CO2, which was used as a supplement to the standard tempering system in die casti

Druh

D - Stať ve sborníku

CEP obor

JP - Průmyslové procesy a zpracování

OECD FORD obor

—

Projekt

—

Návaznosti

I - Institucionalni podpora na dlouhodoby koncepcni rozvoj vyzkumne organizace

Rok uplatnění

2015

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název statě ve sborníku

Unitech 2015

ISBN

—

ISSN

1313-230X

e-ISSN

—

Počet stran výsledku

5

Strana od-do

93-97

Název nakladatele

Technical university of Gabrovo

Místo vydání

Gabrovo

Místo konání akce

Gabrovo

Datum konání akce

1. 1. 2015

Typ akce podle státní příslušnosti

EUR - Evropská akce

Kód UT WoS článku

—