Influence of Testing Methods on the Final Values of the Modulus of Elasticity E

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F46747885%3A24210%2F17%3A00004701" target="_blank" >RIV/46747885:24210/17:00004701 - isvavai.cz</a>

Výsledek na webu

<a href="http://dx.doi.org/10.17973/MMSJ.2017_12_201735" target="_blank" >http://dx.doi.org/10.17973/MMSJ.2017_12_201735</a>

DOI - Digital Object Identifier

<a href="http://dx.doi.org/10.17973/MMSJ.2017_12_201735" target="_blank" >10.17973/MMSJ.2017_12_201735</a>

Jazyk výsledku

angličtina

Název v původním jazyce

Influence of Testing Methods on the Final Values of the Modulus of Elasticity E

Popis výsledku v původním jazyce

In the area of elastic deformation there is linear dependence between the applied stress and final deformation, which is described by the Hooke`s law. Thus stress and strain are proportional to each other and constant of proportionality is termed as modulus of elasticity (even. Young`s modulus). So this material constant characterizes the elastic deformation behavior of the given material and its magnitude represents the very important material constant in all industrial branches and mainly determines the dimensions for the given parts. That is why it`s truly very important to precisely measure its values for different materials. Because of this were in this article used two methods for measurement Young`s modulus E (MPa) – static tensile test and three-point bend test. Main aim was to obtain statistical evaluation about influence of these testing methods on the final values of modulus of elasticity.

Název v anglickém jazyce

Influence of Testing Methods on the Final Values of the Modulus of Elasticity E

Popis výsledku anglicky

In the area of elastic deformation there is linear dependence between the applied stress and final deformation, which is described by the Hooke`s law. Thus stress and strain are proportional to each other and constant of proportionality is termed as modulus of elasticity (even. Young`s modulus). So this material constant characterizes the elastic deformation behavior of the given material and its magnitude represents the very important material constant in all industrial branches and mainly determines the dimensions for the given parts. That is why it`s truly very important to precisely measure its values for different materials. Because of this were in this article used two methods for measurement Young`s modulus E (MPa) – static tensile test and three-point bend test. Main aim was to obtain statistical evaluation about influence of these testing methods on the final values of modulus of elasticity.

Druh

J_SC - Článek v periodiku v databázi SCOPUS

CEP obor

—

OECD FORD obor

20501 - Materials engineering

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2017

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

MM Science Journal

ISSN

1803-1269

e-ISSN

—

Svazek periodika

Vol. 2017

Číslo periodika v rámci svazku

December

Stát vydavatele periodika

CZ - Česká republika

Počet stran výsledku

5

Strana od-do

1942-1946

Kód UT WoS článku

—

EID výsledku v databázi Scopus

2-s2.0-85038114708