The influence of the cutting conditions on the machined surface quality when the CFRP is machined

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F49777513%3A23210%2F15%3A43924944" target="_blank" >RIV/49777513:23210/15:43924944 - isvavai.cz</a>

Výsledek na webu

<a href="http://www.sciencedirect.com/science/article/pii/S1877705815005202" target="_blank" >http://www.sciencedirect.com/science/article/pii/S1877705815005202</a>

DOI - Digital Object Identifier

<a href="http://dx.doi.org/10.1016/j.proeng.2015.01.493" target="_blank" >10.1016/j.proeng.2015.01.493</a>

Jazyk výsledku

angličtina

Název v původním jazyce

The influence of the cutting conditions on the machined surface quality when the CFRP is machined

Popis výsledku v původním jazyce

Composite materials offer very interesting mechanical and physical properties. Recently, they are an increasingly sought-after commodity particularly in the military, aerospace and automotive industries. This is mainly due to the ratio between their weight and the high values of their mechanical properties, which often reach higher values than commonly used materials. This article is focused on milling of composite materials, specifically fiber reinforced plastics produced by filament winding, in termsof cutting conditions which can be used for good surface quality. The proposal of technology, such as determination of cutting conditions, is a very difficult issue because there are many problems with delamination of reinforcement, high tool wear and with filtering of powder which is formed from the chips of these materials.

Název v anglickém jazyce

The influence of the cutting conditions on the machined surface quality when the CFRP is machined

Popis výsledku anglicky

Composite materials offer very interesting mechanical and physical properties. Recently, they are an increasingly sought-after commodity particularly in the military, aerospace and automotive industries. This is mainly due to the ratio between their weight and the high values of their mechanical properties, which often reach higher values than commonly used materials. This article is focused on milling of composite materials, specifically fiber reinforced plastics produced by filament winding, in termsof cutting conditions which can be used for good surface quality. The proposal of technology, such as determination of cutting conditions, is a very difficult issue because there are many problems with delamination of reinforcement, high tool wear and with filtering of powder which is formed from the chips of these materials.

Druh

D - Stať ve sborníku

CEP obor

JR - Ostatní strojírenství

OECD FORD obor

—

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2015

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název statě ve sborníku

Procedia Engineering

ISBN

978-3-901509-99-5

ISSN

1877-7058

e-ISSN

—

Počet stran výsledku

7

Strana od-do

1270-1276

Název nakladatele

Elsevier

Místo vydání

Vídeň

Místo konání akce

Vídeň

Datum konání akce

26. 11. 2014

Typ akce podle státní příslušnosti

WRD - Celosvětová akce

Kód UT WoS článku

—