Investigation of geometric properties achieved by additive manufacturing

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F60162694%3AG43__%2F21%3A00557439" target="_blank" >RIV/60162694:G43__/21:00557439 - isvavai.cz</a>

Výsledek na webu

<a href="http://ieeexplore.ieee.org/xpl/mostRecentIssue.jsp?punumber=9502737" target="_blank" >http://ieeexplore.ieee.org/xpl/mostRecentIssue.jsp?punumber=9502737</a>

DOI - Digital Object Identifier

<a href="http://dx.doi.org/10.1109/ICMT52455.2021.9502748" target="_blank" >10.1109/ICMT52455.2021.9502748</a>

Jazyk výsledku

angličtina

Název v původním jazyce

Investigation of geometric properties achieved by additive manufacturing

Popis výsledku v původním jazyce

Additive manufacturing allows the manufacturing of component complex in shape, which would be impossible to manufacture by conventional methods quickly and efficiently. Evaluation of geometric properties of the manufactured component is one of the critical steps before deployment of the additive manufacturing in aviation. Both micro- and macro-geometry needs to be properly assessed. This paper presents viable methods for both evaluation and assessment of the surface of the manufactured component, which is directly dependent on the parameters selected during the manufacturing. Monitored parameters were chosen based on the shape of the tested component. Selected parameter from macrogeometry is roundness and deviation of roundness from diameter. As for microgeometry, the surface roughness was explored. Considering the complex shape of the surface of the tested component, the proper parameter to describe the surface roughness had to be found as well.

Název v anglickém jazyce

Investigation of geometric properties achieved by additive manufacturing

Popis výsledku anglicky

Additive manufacturing allows the manufacturing of component complex in shape, which would be impossible to manufacture by conventional methods quickly and efficiently. Evaluation of geometric properties of the manufactured component is one of the critical steps before deployment of the additive manufacturing in aviation. Both micro- and macro-geometry needs to be properly assessed. This paper presents viable methods for both evaluation and assessment of the surface of the manufactured component, which is directly dependent on the parameters selected during the manufacturing. Monitored parameters were chosen based on the shape of the tested component. Selected parameter from macrogeometry is roundness and deviation of roundness from diameter. As for microgeometry, the surface roughness was explored. Considering the complex shape of the surface of the tested component, the proper parameter to describe the surface roughness had to be found as well.

Druh

D - Stať ve sborníku

CEP obor

—

OECD FORD obor

20301 - Mechanical engineering

Projekt

—

Návaznosti

I - Institucionalni podpora na dlouhodoby koncepcni rozvoj vyzkumne organizace

Rok uplatnění

2021

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název statě ve sborníku

2021 8th International Conference on Military Technologies, ICMT 2021 - Proceedings

ISBN

978-1-6654-3724-0

ISSN

—

e-ISSN

—

Počet stran výsledku

8

Strana od-do

—

Název nakladatele

Institute of Electrical and Electronics Engineers Inc.

Místo vydání

Piscataway, USA

Místo konání akce

Brno, the Czech Republic

Datum konání akce

8. 6. 2021

Typ akce podle státní příslušnosti

WRD - Celosvětová akce

Kód UT WoS článku

—