Working variables optimization of resistance spot welding

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F60460709%3A41310%2F14%3A67181" target="_blank" >RIV/60460709:41310/14:67181 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Working variables optimization of resistance spot welding

Popis výsledku v původním jazyce

Resistance welding ranks among progressive and in practice often used manufacturing tech-niques of rigid joints. It is applied in single-part production, short-run production as well as in mass production. The basis of this method is in the utilization of the Joulean heat, which arises at the passage of current through connected sheets at collective influence of compressive force. The aim of the carried out tests was the optimization of the resistance spot welding working vari-ables, concretely the determination of the dependence between the rupture force of spot welds made using sheets of different thickness and different welding conditions. For carrying out of this aim 650 assemblies were prepared. The test specimens of dimensions 100 x 25 mm and thickness of 0.5 mm, 1.0 mm, 1.5 mm, 2.0 mm, 2.5 mm and 3.0 mm were made from low carbon steel. In the place determined for welding the test specimens were corundum blasted and then degreased. The welding of two specimens always of the same

Název v anglickém jazyce

Working variables optimization of resistance spot welding

Popis výsledku anglicky

Resistance welding ranks among progressive and in practice often used manufacturing tech-niques of rigid joints. It is applied in single-part production, short-run production as well as in mass production. The basis of this method is in the utilization of the Joulean heat, which arises at the passage of current through connected sheets at collective influence of compressive force. The aim of the carried out tests was the optimization of the resistance spot welding working vari-ables, concretely the determination of the dependence between the rupture force of spot welds made using sheets of different thickness and different welding conditions. For carrying out of this aim 650 assemblies were prepared. The test specimens of dimensions 100 x 25 mm and thickness of 0.5 mm, 1.0 mm, 1.5 mm, 2.0 mm, 2.5 mm and 3.0 mm were made from low carbon steel. In the place determined for welding the test specimens were corundum blasted and then degreased. The welding of two specimens always of the same

Druh

J_x - Nezařazeno - Článek v odborném periodiku (Jimp, Jsc a Jost)

CEP obor

JR - Ostatní strojírenství

OECD FORD obor

—

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2014

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Manufacturing Technology

ISSN

1213-2489

e-ISSN

—

Svazek periodika

14

Číslo periodika v rámci svazku

4

Stát vydavatele periodika

CZ - Česká republika

Počet stran výsledku

6

Strana od-do

522-527

Kód UT WoS článku

—

EID výsledku v databázi Scopus

—