TENSILE RESISTANCE OF WHEELED COMBINE HARVESTER

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F60460709%3A41310%2F15%3A67395" target="_blank" >RIV/60460709:41310/15:67395 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

TENSILE RESISTANCE OF WHEELED COMBINE HARVESTER

Popis výsledku v původním jazyce

This article examines the influence of tires depending on tensile resistance of combine harvester. When low-pressure tires are one of the ways to respond to the increasing weight of self-propelled machines.. Determination of the tensile resistance valueis not simple, and it was necessary to modify the methodology of measuring. Tensile resistance determination was based on measurements of a drawbar pull. The drawbar pull was measured as follows. The combine harvester John Deere S680i was towed by a tractor. A pull dynamometer, from which the pulling force was read, was used as a tow bar. Measuring was carried out on the asphalt surface with maximum slope of 0,2 and a path length of 120 meters. The speed with which the combine harvester was pulled corresponds with the usual working speeds, by which the combine harvester moves on the land at the time of harvest. The variants of the measurements speed were 4, 6 and 8 km*h-1 and each variant was repeated two times. Therefore we can observe

Název v anglickém jazyce

TENSILE RESISTANCE OF WHEELED COMBINE HARVESTER

Popis výsledku anglicky

This article examines the influence of tires depending on tensile resistance of combine harvester. When low-pressure tires are one of the ways to respond to the increasing weight of self-propelled machines.. Determination of the tensile resistance valueis not simple, and it was necessary to modify the methodology of measuring. Tensile resistance determination was based on measurements of a drawbar pull. The drawbar pull was measured as follows. The combine harvester John Deere S680i was towed by a tractor. A pull dynamometer, from which the pulling force was read, was used as a tow bar. Measuring was carried out on the asphalt surface with maximum slope of 0,2 and a path length of 120 meters. The speed with which the combine harvester was pulled corresponds with the usual working speeds, by which the combine harvester moves on the land at the time of harvest. The variants of the measurements speed were 4, 6 and 8 km*h-1 and each variant was repeated two times. Therefore we can observe

Druh

D - Stať ve sborníku

CEP obor

GB - Zemědělské stroje a stavby

OECD FORD obor

—

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2015

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název statě ve sborníku

14th International Scientific Conference on Engineering for Rural Development 2015

ISBN

—

ISSN

1691-5976

e-ISSN

—

Počet stran výsledku

5

Strana od-do

46-50

Název nakladatele

Latvia University of Agriculture

Místo vydání

Jelgava

Místo konání akce

Jelgava

Datum konání akce

20. 5. 2015

Typ akce podle státní příslušnosti

WRD - Celosvětová akce

Kód UT WoS článku

—