Research on surface treatment of alloy AlCu4Mg adhesive bonded with structural single-component epoxy adhesives

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F60460709%3A41310%2F15%3A68995" target="_blank" >RIV/60460709:41310/15:68995 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Research on surface treatment of alloy AlCu4Mg adhesive bonded with structural single-component epoxy adhesives

Popis výsledku v původním jazyce

Adhesive bonding technology is among the basic methods of joining. Treatment of bonded surface is seen as an essential technology for improving the strength of the bond. Improper treatment of bonded surface reduces the bonding strength and at the same time may increase the cost of manufacturing the bond. The aim of the research was to evaluate the treatment of AlCu4Mg surface bonded by using single-component epoxy, which is commonly used in the transportation industry. This article describes the effectof bonded surface treatment (mechanical treatment of Al2O3 blasting, chemical treatment by degreasing, without modification). Evaluation of individual bonded surface modification was performed according to ČSN EN 1465. From the results of the experimentsit can be concluded that all tested adhesives did not confirm the hypothesis H0 (p < 0.05). It follows that there is a difference in the treatment of the bonded surface. The influence of the treatment of bonded surface on adhesive bond s

Název v anglickém jazyce

Research on surface treatment of alloy AlCu4Mg adhesive bonded with structural single-component epoxy adhesives

Popis výsledku anglicky

Adhesive bonding technology is among the basic methods of joining. Treatment of bonded surface is seen as an essential technology for improving the strength of the bond. Improper treatment of bonded surface reduces the bonding strength and at the same time may increase the cost of manufacturing the bond. The aim of the research was to evaluate the treatment of AlCu4Mg surface bonded by using single-component epoxy, which is commonly used in the transportation industry. This article describes the effectof bonded surface treatment (mechanical treatment of Al2O3 blasting, chemical treatment by degreasing, without modification). Evaluation of individual bonded surface modification was performed according to ČSN EN 1465. From the results of the experimentsit can be concluded that all tested adhesives did not confirm the hypothesis H0 (p < 0.05). It follows that there is a difference in the treatment of the bonded surface. The influence of the treatment of bonded surface on adhesive bond s

Druh

J_x - Nezařazeno - Článek v odborném periodiku (Jimp, Jsc a Jost)

CEP obor

JR - Ostatní strojírenství

OECD FORD obor

—

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2015

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Manufacturing Technology

ISSN

1213-2489

e-ISSN

—

Svazek periodika

15

Číslo periodika v rámci svazku

4

Stát vydavatele periodika

CZ - Česká republika

Počet stran výsledku

5

Strana od-do

629-633

Kód UT WoS článku

—

EID výsledku v databázi Scopus

—