Dust concentration in air during the aluminium alloy AlCu4Mg milling operations

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F60460709%3A41310%2F17%3A74293" target="_blank" >RIV/60460709:41310/17:74293 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Dust concentration in air during the aluminium alloy AlCu4Mg milling operations

Popis výsledku v původním jazyce

During the metal machining amount of dust is generated which can influence significantly surroundings, but mainly workers are exposed to dust pollution. The aim of this paper is to present results of microclimatic research focused on dust pollution in workshop during the milling of aluminium alloy workpieces. The concentration of air dust was measured by the DustTRAK II Model 8530 aerosol monitor. Using the special impactors the PM1, PM2,5, PM4, PM10 size fractions were also measured. Obtained results of measurements and concentrations of different size of dust particles were analysed. Results of measurements under different milling conditions are generalized. The conclusion of the research is that it is necessary to watch the optimization of the milling process as well as secondary effects of the technological operations and inner environment of workshops which can be contaminated by chemical substances as well as dust particles.

Název v anglickém jazyce

Dust concentration in air during the aluminium alloy AlCu4Mg milling operations

Popis výsledku anglicky

During the metal machining amount of dust is generated which can influence significantly surroundings, but mainly workers are exposed to dust pollution. The aim of this paper is to present results of microclimatic research focused on dust pollution in workshop during the milling of aluminium alloy workpieces. The concentration of air dust was measured by the DustTRAK II Model 8530 aerosol monitor. Using the special impactors the PM1, PM2,5, PM4, PM10 size fractions were also measured. Obtained results of measurements and concentrations of different size of dust particles were analysed. Results of measurements under different milling conditions are generalized. The conclusion of the research is that it is necessary to watch the optimization of the milling process as well as secondary effects of the technological operations and inner environment of workshops which can be contaminated by chemical substances as well as dust particles.

Druh

J_SC - Článek v periodiku v databázi SCOPUS

CEP obor

—

OECD FORD obor

20501 - Materials engineering

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2017

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Manufacturing Technology

ISSN

1213-2489

e-ISSN

—

Svazek periodika

17

Číslo periodika v rámci svazku

5

Stát vydavatele periodika

CZ - Česká republika

Počet stran výsledku

5

Strana od-do

729-733

Kód UT WoS článku

—

EID výsledku v databázi Scopus

2-s2.0-85030532877