Research on aluminium alloy AlCu4Mg surface machined by abrasive water jet

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F60460709%3A41310%2F17%3A75318" target="_blank" >RIV/60460709:41310/17:75318 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Research on aluminium alloy AlCu4Mg surface machined by abrasive water jet

Popis výsledku v původním jazyce

The paper deals with a machining of the aluminium alloy by means of an unconventional technology, i.e. an abrasive water jet (AWJ). The paper deals with a study of an influence of the abrasive water jet at its impact on a surface of the machined material, i.e. the aluminium alloy AlCu4Mg of a thickness 20 mm. A topography of the machined surface is evaluated within the research by means of roughness parameters. A surface analysis is also evaluated by means of a scanning electron microscopy (SEM) depending on a cutting speed and a mass flow of the abrasivum. The research results proved an increased influence of the cutting speed and the mass flow of the abrasivum. The optimum cutting speed was 50 mm.min-1, the cut was uniform without a significant grooved zone typical for cuts by means of AWJ technology.

Název v anglickém jazyce

Research on aluminium alloy AlCu4Mg surface machined by abrasive water jet

Popis výsledku anglicky

The paper deals with a machining of the aluminium alloy by means of an unconventional technology, i.e. an abrasive water jet (AWJ). The paper deals with a study of an influence of the abrasive water jet at its impact on a surface of the machined material, i.e. the aluminium alloy AlCu4Mg of a thickness 20 mm. A topography of the machined surface is evaluated within the research by means of roughness parameters. A surface analysis is also evaluated by means of a scanning electron microscopy (SEM) depending on a cutting speed and a mass flow of the abrasivum. The research results proved an increased influence of the cutting speed and the mass flow of the abrasivum. The optimum cutting speed was 50 mm.min-1, the cut was uniform without a significant grooved zone typical for cuts by means of AWJ technology.

Druh

J_SC - Článek v periodiku v databázi SCOPUS

CEP obor

—

OECD FORD obor

20301 - Mechanical engineering

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2017

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Manufacturing Technology

ISSN

1213-2489

e-ISSN

—

Svazek periodika

17

Číslo periodika v rámci svazku

6

Stát vydavatele periodika

CZ - Česká republika

Počet stran výsledku

6

Strana od-do

925-930

Kód UT WoS článku

—

EID výsledku v databázi Scopus

2-s2.0-85038212565