Comparative Study on Standardized Ignition Sources: Exploration of the Initial Igniting Volume of Standardized Ignition Sources for the Determination of Explosion Characteristics

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F61989100%3A27200%2F22%3A10249915" target="_blank" >RIV/61989100:27200/22:10249915 - isvavai.cz</a>

Výsledek na webu

<a href="https://www.cetjournal.it/cet/22/90/087.pdf" target="_blank" >https://www.cetjournal.it/cet/22/90/087.pdf</a>

DOI - Digital Object Identifier

<a href="http://dx.doi.org/10.3303/CET2290087" target="_blank" >10.3303/CET2290087</a>

Jazyk výsledku

angličtina

Název v původním jazyce

Comparative Study on Standardized Ignition Sources: Exploration of the Initial Igniting Volume of Standardized Ignition Sources for the Determination of Explosion Characteristics

Popis výsledku v původním jazyce

There are several standardized ignition sources in use for the determination of explosion characteristics of gases, vapors and dusts. In the standards the ignition source is stated, but they vary in stating other characteristics like burning duration, energy or burning volume. Since heat is not visible under normal circumstances a Schlieren-Technique was used to make the full heating volume and not just the flames visible. While an earlier paper of the authors focused on the ignition energy and burning duration of four standardized ignition sources, this paper focuses on the initial igniting volume, the ratio between initial igniting volume and the test-vessel size and other phenomena that were observed with the Schlieren-Technique.

Název v anglickém jazyce

Comparative Study on Standardized Ignition Sources: Exploration of the Initial Igniting Volume of Standardized Ignition Sources for the Determination of Explosion Characteristics

Popis výsledku anglicky

There are several standardized ignition sources in use for the determination of explosion characteristics of gases, vapors and dusts. In the standards the ignition source is stated, but they vary in stating other characteristics like burning duration, energy or burning volume. Since heat is not visible under normal circumstances a Schlieren-Technique was used to make the full heating volume and not just the flames visible. While an earlier paper of the authors focused on the ignition energy and burning duration of four standardized ignition sources, this paper focuses on the initial igniting volume, the ratio between initial igniting volume and the test-vessel size and other phenomena that were observed with the Schlieren-Technique.

Druh

J_SC - Článek v periodiku v databázi SCOPUS

CEP obor

—

OECD FORD obor

30305 - Occupational health

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2022

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Chemical Engineering Transactions

ISSN

2283-9216

e-ISSN

—

Svazek periodika

90

Číslo periodika v rámci svazku

květen

Stát vydavatele periodika

IT - Italská republika

Počet stran výsledku

6

Strana od-do

517-522

Kód UT WoS článku

—

EID výsledku v databázi Scopus

2-s2.0-85131264441