Laser Cutting of Nickel Superalloy Haynes 718

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F61989100%3A27230%2F11%3A86079718" target="_blank" >RIV/61989100:27230/11:86079718 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Laser Cutting of Nickel Superalloy Haynes 718

Popis výsledku v původním jazyce

This article deals with the application of laser technology in the area of nickel superalloy laser cutting intended for application in the aircraft industry. The main goal is to outline possibilities of use of the laser technology, primarily its application in the area of 3D material cutting. The experimental part focuses on the optimization of section parameters using a gas CO2 laser. The experiment was performed on the Wibro Delta laser system designed for sizable parts. Test samples were made from the high strength alloy Haynes 718 that belongs to the nickel alloy group. Originating cuts are evaluated primarily from the point of view of cut quality and accompanying undesirable phenomena occurring in the process of cutting. In conclusion the resultsachieved in the metallographic laboratory are described and analyzed.

Název v anglickém jazyce

Laser Cutting of Nickel Superalloy Haynes 718

Popis výsledku anglicky

This article deals with the application of laser technology in the area of nickel superalloy laser cutting intended for application in the aircraft industry. The main goal is to outline possibilities of use of the laser technology, primarily its application in the area of 3D material cutting. The experimental part focuses on the optimization of section parameters using a gas CO2 laser. The experiment was performed on the Wibro Delta laser system designed for sizable parts. Test samples were made from the high strength alloy Haynes 718 that belongs to the nickel alloy group. Originating cuts are evaluated primarily from the point of view of cut quality and accompanying undesirable phenomena occurring in the process of cutting. In conclusion the resultsachieved in the metallographic laboratory are described and analyzed.

Druh

J_x - Nezařazeno - Článek v odborném periodiku (Jimp, Jsc a Jost)

CEP obor

JR - Ostatní strojírenství

OECD FORD obor

—

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2011

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Technologické inžinierstvo

ISSN

1336-5967

e-ISSN

—

Svazek periodika

VIII

Číslo periodika v rámci svazku

2

Stát vydavatele periodika

SK - Slovenská republika

Počet stran výsledku

4

Strana od-do

17-19

Kód UT WoS článku

—

EID výsledku v databázi Scopus

—