Laser Cutting of Materials of Various Thicnesses

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F61989100%3A27230%2F12%3A86084289" target="_blank" >RIV/61989100:27230/12:86084289 - isvavai.cz</a>

Výsledek na webu

<a href="http://www.scopus.com" target="_blank" >http://www.scopus.com</a>

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Laser Cutting of Materials of Various Thicnesses

Popis výsledku v původním jazyce

Thise paper deals with the application of laser technology and optimizing the parameters for cutting nickel alloy. The theoretical part of the paper describes various types of lasers, their principles and usage. The experimental part focuses on optimizing the section parameteres of Haynes 718 alloy using a CO2 gas laser. This alloy is employed in the production of components for the aircraft industry. The experiment was performed on the Wibro Delta laser system designed for sizable parts. The actual section is measured with respect to its quality and any accompanying side effects that occur during the process. In this case, laser output and cutting speed were the parameters with most influence on the final cut. The summary explains the results achievedin a metallographic laboratory.

Název v anglickém jazyce

Laser Cutting of Materials of Various Thicnesses

Popis výsledku anglicky

Thise paper deals with the application of laser technology and optimizing the parameters for cutting nickel alloy. The theoretical part of the paper describes various types of lasers, their principles and usage. The experimental part focuses on optimizing the section parameteres of Haynes 718 alloy using a CO2 gas laser. This alloy is employed in the production of components for the aircraft industry. The experiment was performed on the Wibro Delta laser system designed for sizable parts. The actual section is measured with respect to its quality and any accompanying side effects that occur during the process. In this case, laser output and cutting speed were the parameters with most influence on the final cut. The summary explains the results achievedin a metallographic laboratory.

Druh

J_x - Nezařazeno - Článek v odborném periodiku (Jimp, Jsc a Jost)

CEP obor

JR - Ostatní strojírenství

OECD FORD obor

—

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2012

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Acta Polytechnica

ISSN

1210-2709

e-ISSN

—

Svazek periodika

4

Číslo periodika v rámci svazku

52

Stát vydavatele periodika

CZ - Česká republika

Počet stran výsledku

6

Strana od-do

62-67

Kód UT WoS článku

—

EID výsledku v databázi Scopus

2-s2.0-84865984565