Determination of Rotary Joint Stiffness Coefficients using Modal Analysis
Identifikátory výsledku
Kód výsledku v IS VaVaI
<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F61989100%3A27230%2F25%3A10259126" target="_blank" >RIV/61989100:27230/25:10259126 - isvavai.cz</a>
Výsledek na webu
<a href="http://experimentalni-mechanika.cz/cs/konference/konference/2025.html" target="_blank" >http://experimentalni-mechanika.cz/cs/konference/konference/2025.html</a>
DOI - Digital Object Identifier
—
Alternativní jazyky
Jazyk výsledku
angličtina
Název v původním jazyce
Determination of Rotary Joint Stiffness Coefficients using Modal Analysis
Popis výsledku v původním jazyce
The paper describes the methodology for determining the stiffness coefficients of a kinematic joint. The subject of investigation is a joint providing rotary motion of one arm of the 4R Bennett mechanism. The basic principle is in the FE model updating method, in which the experimentally measured natural frequencies of the analysed assembly are used to optimize the stiffness coefficients of the bushing connector representing the kinematic joint. The use of bushing with appropriately adjusted stiffness parameters significantly improves the accuracy of the numerical model compared to the model with rigid connector.
Název v anglickém jazyce
Determination of Rotary Joint Stiffness Coefficients using Modal Analysis
Popis výsledku anglicky
The paper describes the methodology for determining the stiffness coefficients of a kinematic joint. The subject of investigation is a joint providing rotary motion of one arm of the 4R Bennett mechanism. The basic principle is in the FE model updating method, in which the experimentally measured natural frequencies of the analysed assembly are used to optimize the stiffness coefficients of the bushing connector representing the kinematic joint. The use of bushing with appropriately adjusted stiffness parameters significantly improves the accuracy of the numerical model compared to the model with rigid connector.
Klasifikace
Druh
D - Stať ve sborníku
CEP obor
—
OECD FORD obor
20300 - Mechanical engineering
Návaznosti výsledku
Projekt
—
Návaznosti
S - Specificky vyzkum na vysokych skolach
Ostatní
Rok uplatnění
2025
Kód důvěrnosti údajů
S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů
Údaje specifické pro druh výsledku
Název statě ve sborníku
Experimental Stress Analysis : 63rd international conference : 27. - 29. May, 2025, Klášter Hradiště nad Jizerou, Czech Republic : proceedings of full papers
ISBN
978-80-7494-763-6
ISSN
—
e-ISSN
—
Počet stran výsledku
5
Strana od-do
66-70
Název nakladatele
Technical University of Liberec
Místo vydání
Liberec
Místo konání akce
Klášter Hradiště nad Jizerou
Datum konání akce
27. 5. 2025
Typ akce podle státní příslušnosti
EUR - Evropská akce
Kód UT WoS článku
—