Calorimetric measurements and theoretical calculations of Fe-C-Cr based systems
Identifikátory výsledku
Kód výsledku v IS VaVaI
<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F61989100%3A27360%2F18%3A10241416" target="_blank" >RIV/61989100:27360/18:10241416 - isvavai.cz</a>
Výsledek na webu
—
DOI - Digital Object Identifier
—
Alternativní jazyky
Jazyk výsledku
angličtina
Název v původním jazyce
Calorimetric measurements and theoretical calculations of Fe-C-Cr based systems
Popis výsledku v původním jazyce
Two alloys based on Fe-C-Cr were studied. Alloy A contained carbon of 0.34 wt. % and chromium of 2.97 wt. %. Alloy B contained carbon of 0.34 wt. % and chromium of 4,760 wt. %. Heat capacities were studied in the low and high-temperature area. The heat capacities were obtained using Differential Scanning Calorimetry (DSC). The Setaram MHTC (Multi High-Temperature Calorimeter) 96 with a 3D DSC sensor was used for experiments with the use of the DSC method. Measurements were done in an inert atmosphere of pure argon by a heating rate of 5oC min-1. The experimental data were compared and discussed with the calculation results using SW Thermo-Calc (TC), FactSage (FS) and IDS.
Název v anglickém jazyce
Calorimetric measurements and theoretical calculations of Fe-C-Cr based systems
Popis výsledku anglicky
Two alloys based on Fe-C-Cr were studied. Alloy A contained carbon of 0.34 wt. % and chromium of 2.97 wt. %. Alloy B contained carbon of 0.34 wt. % and chromium of 4,760 wt. %. Heat capacities were studied in the low and high-temperature area. The heat capacities were obtained using Differential Scanning Calorimetry (DSC). The Setaram MHTC (Multi High-Temperature Calorimeter) 96 with a 3D DSC sensor was used for experiments with the use of the DSC method. Measurements were done in an inert atmosphere of pure argon by a heating rate of 5oC min-1. The experimental data were compared and discussed with the calculation results using SW Thermo-Calc (TC), FactSage (FS) and IDS.
Klasifikace
Druh
O - Ostatní výsledky
CEP obor
—
OECD FORD obor
20501 - Materials engineering
Návaznosti výsledku
Projekt
Výsledek vznikl pri realizaci vícero projektů. Více informací v záložce Projekty.
Návaznosti
P - Projekt vyzkumu a vyvoje financovany z verejnych zdroju (s odkazem do CEP)
Ostatní
Rok uplatnění
2018
Kód důvěrnosti údajů
S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů