Deviation of coordinates of small-dimension holes in fiberboard

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F62156489%3A43410%2F23%3A43922014" target="_blank" >RIV/62156489:43410/23:43922014 - isvavai.cz</a>

Výsledek na webu

<a href="https://doi.org/10.1080/17480272.2022.2121661" target="_blank" >https://doi.org/10.1080/17480272.2022.2121661</a>

DOI - Digital Object Identifier

<a href="http://dx.doi.org/10.1080/17480272.2022.2121661" target="_blank" >10.1080/17480272.2022.2121661</a>

Jazyk výsledku

angličtina

Název v původním jazyce

Deviation of coordinates of small-dimension holes in fiberboard

Popis výsledku v původním jazyce

This paper aims at the influence of drilling conditions (feed rate and material type) upon the coordinates deviation (deviation from the nominal location) of holes in wood-based materials: high-density fiberboard (HDF), medium-density fiberboard (MDF), and hard fiberboard (HB). These were tested with drill bits of 0.5, 1.0, 2.0, and 3.0 mm. Coordinates deviation was measured with computer vision-based scripts. The conclusion obtained is as follows: drill coordinates deviation increases with feed rate and material hardness. Tool diameter influence is less obvious due to two factors: its slenderness and difficultness in the hole initiation process. The results obtained are generally in line with other works on micro-drilling and can be used as references for other wood-related works.

Název v anglickém jazyce

Deviation of coordinates of small-dimension holes in fiberboard

Popis výsledku anglicky

This paper aims at the influence of drilling conditions (feed rate and material type) upon the coordinates deviation (deviation from the nominal location) of holes in wood-based materials: high-density fiberboard (HDF), medium-density fiberboard (MDF), and hard fiberboard (HB). These were tested with drill bits of 0.5, 1.0, 2.0, and 3.0 mm. Coordinates deviation was measured with computer vision-based scripts. The conclusion obtained is as follows: drill coordinates deviation increases with feed rate and material hardness. Tool diameter influence is less obvious due to two factors: its slenderness and difficultness in the hole initiation process. The results obtained are generally in line with other works on micro-drilling and can be used as references for other wood-related works.

Druh

J_imp - Článek v periodiku v databázi Web of Science

CEP obor

—

OECD FORD obor

20502 - Paper and wood

Projekt

—

Návaznosti

I - Institucionalni podpora na dlouhodoby koncepcni rozvoj vyzkumne organizace

Rok uplatnění

2023

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Wood Material Science and Engineering

ISSN

1748-0272

e-ISSN

1748-0280

Svazek periodika

18

Číslo periodika v rámci svazku

4

Stát vydavatele periodika

GB - Spojené království Velké Británie a Severního Irska

Počet stran výsledku

6

Strana od-do

1237-1242

Kód UT WoS článku

000858059700001

EID výsledku v databázi Scopus

2-s2.0-85139006276