Overview of S(T)EM electron detectors with garnet scintillators: Some potentials and limits

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F68081731%3A_____%2F21%3A00544784" target="_blank" >RIV/68081731:_____/21:00544784 - isvavai.cz</a>

Nalezeny alternativní kódy

RIV/00216208:11320/21:10435345

Výsledek na webu

<a href="https://analyticalsciencejournals.onlinelibrary.wiley.com/doi/10.1002/jemt.23634" target="_blank" >https://analyticalsciencejournals.onlinelibrary.wiley.com/doi/10.1002/jemt.23634</a>

DOI - Digital Object Identifier

<a href="http://dx.doi.org/10.1002/jemt.23634" target="_blank" >10.1002/jemt.23634</a>

Jazyk výsledku

angličtina

Název v původním jazyce

Overview of S(T)EM electron detectors with garnet scintillators: Some potentials and limits

Popis výsledku v původním jazyce

The paper is focused on a complete configuration and design of a scintillation electron detector in scanning electron and/or scanning transmission electron microscopes (S(T)EM) with garnet scintillators. All processes related to the scintillator and light guide were analyzed. In more detail, excitation electron trajectories and absorbed energy distributions, efficiencies and kinetics of scintillators, as well as the influence of their anti-charging coatings and their substrates, assigned optical properties, and light guide efficiencies of different configurations were presented and discussed. The results indicate problems with low-energy detection below 1 keV when the scandium conductive coating with a thickness of only 3 nm must be used to allow electron penetration without significant losses. It was shown that the short rise and decay time and low afterglow of LuGdGaAG:Ce liquid-phase epitaxy garnet film scintillators guarantee a strong modulation transfer function of the entire imaging system resulting in a contrast transfer ability up to 0.6 lp/pixel. Small film scintillator thicknesses were found to be an advantage due to the low signal self-absorption. The optical absorption coefficients, refractive indices, and the mirror optical reflectance of materials involved in the light transport to the photomultiplier tube photocathode were investigated. The computer-optimized design SCIUNI application was used to configure the optimized light guide system. It was shown that nonoptimized edge-guided systems possess very poor light guiding efficiency as low as 1%, while even very complex optimized ones can achieve more than 20%.

Název v anglickém jazyce

Overview of S(T)EM electron detectors with garnet scintillators: Some potentials and limits

Popis výsledku anglicky

The paper is focused on a complete configuration and design of a scintillation electron detector in scanning electron and/or scanning transmission electron microscopes (S(T)EM) with garnet scintillators. All processes related to the scintillator and light guide were analyzed. In more detail, excitation electron trajectories and absorbed energy distributions, efficiencies and kinetics of scintillators, as well as the influence of their anti-charging coatings and their substrates, assigned optical properties, and light guide efficiencies of different configurations were presented and discussed. The results indicate problems with low-energy detection below 1 keV when the scandium conductive coating with a thickness of only 3 nm must be used to allow electron penetration without significant losses. It was shown that the short rise and decay time and low afterglow of LuGdGaAG:Ce liquid-phase epitaxy garnet film scintillators guarantee a strong modulation transfer function of the entire imaging system resulting in a contrast transfer ability up to 0.6 lp/pixel. Small film scintillator thicknesses were found to be an advantage due to the low signal self-absorption. The optical absorption coefficients, refractive indices, and the mirror optical reflectance of materials involved in the light transport to the photomultiplier tube photocathode were investigated. The computer-optimized design SCIUNI application was used to configure the optimized light guide system. It was shown that nonoptimized edge-guided systems possess very poor light guiding efficiency as low as 1%, while even very complex optimized ones can achieve more than 20%.

Druh

J_imp - Článek v periodiku v databázi Web of Science

CEP obor

—

OECD FORD obor

20201 - Electrical and electronic engineering

Projekt

Výsledek vznikl pri realizaci vícero projektů. Více informací v záložce Projekty.

Návaznosti

P - Projekt vyzkumu a vyvoje financovany z verejnych zdroju (s odkazem do CEP)

Rok uplatnění

2021

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Microscopy Research and Technique

ISSN

1059-910X

e-ISSN

1097-0029

Svazek periodika

84

Číslo periodika v rámci svazku

4

Stát vydavatele periodika

US - Spojené státy americké

Počet stran výsledku

18

Strana od-do

753-770

Kód UT WoS článku

000583346100001

EID výsledku v databázi Scopus

2-s2.0-85096796587