Comparison of surface roughness quality created by abrasive water jet and CO2 laser beam cutting

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F68145535%3A_____%2F12%3A00381676" target="_blank" >RIV/68145535:_____/12:00381676 - isvavai.cz</a>

Výsledek na webu

<a href="http://hrcak.srce.hr/index.php?show=clanak&id_clanak_jezik=129054" target="_blank" >http://hrcak.srce.hr/index.php?show=clanak&id_clanak_jezik=129054</a>

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Comparison of surface roughness quality created by abrasive water jet and CO2 laser beam cutting

Popis výsledku v původním jazyce

This paper deals with an evaluation of the surface roughness quality created by abrasive water jet and by CO2 laser, in terms of influence of the selected technological parameters on the final quality of machined surfaces. The main objective of these experimental studies was to consider the use of both technologies for cutting of difficult to cut materials. Experiments presented in the paper were carried out on titanium ASTM B265-99 samples. The machined surfaces of samples were measured by an optical profilometer. Subsequently, selected topographical characteristics were studied. The obtained data were used for comparison of surface roughness parameters Ra in different depths. Based on achieved results the comparison of both technologies was made.

Název v anglickém jazyce

Comparison of surface roughness quality created by abrasive water jet and CO2 laser beam cutting

Popis výsledku anglicky

This paper deals with an evaluation of the surface roughness quality created by abrasive water jet and by CO2 laser, in terms of influence of the selected technological parameters on the final quality of machined surfaces. The main objective of these experimental studies was to consider the use of both technologies for cutting of difficult to cut materials. Experiments presented in the paper were carried out on titanium ASTM B265-99 samples. The machined surfaces of samples were measured by an optical profilometer. Subsequently, selected topographical characteristics were studied. The obtained data were used for comparison of surface roughness parameters Ra in different depths. Based on achieved results the comparison of both technologies was made.

Druh

J_x - Nezařazeno - Článek v odborném periodiku (Jimp, Jsc a Jost)

CEP obor

JQ - Strojní zařízení a nástroje

OECD FORD obor

—

Projekt

<a href="/cs/project/ED2.1.00%2F03.0082" target="_blank" >ED2.1.00/03.0082: Institut čistých technologií těžby a užití energetických surovin</a><br>

Návaznosti

I - Institucionalni podpora na dlouhodoby koncepcni rozvoj vyzkumne organizace

Rok uplatnění

2012

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Technicki vjesnik - Technical Gazette

ISSN

1330-3651

e-ISSN

—

Svazek periodika

19

Číslo periodika v rámci svazku

3

Stát vydavatele periodika

HR - Chorvatská republika

Počet stran výsledku

5

Strana od-do

481-485

Kód UT WoS článku

000309164400003

EID výsledku v databázi Scopus

—