A comparison of methods for calculating notch tip strains and stresses under multiaxial loading

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F68407700%3A21220%2F16%3A00306042" target="_blank" >RIV/68407700:21220/16:00306042 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

A comparison of methods for calculating notch tip strains and stresses under multiaxial loading

Popis výsledku v původním jazyce

Selected methods for calculating notch tip strains and stresses in elastic–plastic isotropic bodies subjected to multiaxial monotonic loading were compared. The methods use sets of equations where hypothetical notch tip elastic strains and stresses obtained from FEM calculations serve as an input. The comparison was performed within two separate groups of methods: the first group consists of the methods intended for cases of multiaxial proportional loading and the second group deals with multiaxial non-proportional loading. Originally, the precision of the methods was validated by comparison with results obtained from elastic–plastic FEM analyses. Since computer performance at the time was lower than nowadays, verification of the proposed methods on FEM models with a finer mesh was needed. Such verification was carried out and is presented in this paper. The effect of various formulations of material stress–strain curve was also evaluated.

Název v anglickém jazyce

A comparison of methods for calculating notch tip strains and stresses under multiaxial loading

Popis výsledku anglicky

Selected methods for calculating notch tip strains and stresses in elastic–plastic isotropic bodies subjected to multiaxial monotonic loading were compared. The methods use sets of equations where hypothetical notch tip elastic strains and stresses obtained from FEM calculations serve as an input. The comparison was performed within two separate groups of methods: the first group consists of the methods intended for cases of multiaxial proportional loading and the second group deals with multiaxial non-proportional loading. Originally, the precision of the methods was validated by comparison with results obtained from elastic–plastic FEM analyses. Since computer performance at the time was lower than nowadays, verification of the proposed methods on FEM models with a finer mesh was needed. Such verification was carried out and is presented in this paper. The effect of various formulations of material stress–strain curve was also evaluated.

Druh

J_x - Nezařazeno - Článek v odborném periodiku (Jimp, Jsc a Jost)

CEP obor

JL - Únava materiálu a lomová mechanika

OECD FORD obor

—

Projekt

<a href="/cs/project/GA15-18274S" target="_blank" >GA15-18274S: Účinné metody odhadu životnosti pro obecné víceosé namáhání</a><br>

Návaznosti

P - Projekt vyzkumu a vyvoje financovany z verejnych zdroju (s odkazem do CEP)

Rok uplatnění

2016

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Frattura ed Integrita Strutturale

ISSN

1971-8993

e-ISSN

—

Svazek periodika

—

Číslo periodika v rámci svazku

38

Stát vydavatele periodika

IT - Italská republika

Počet stran výsledku

7

Strana od-do

237-243

Kód UT WoS článku

000393175500032

EID výsledku v databázi Scopus

2-s2.0-84991294627