Creating and evaluating replicas of surfaces machined by laser beam

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F70883521%3A28110%2F17%3A63516063" target="_blank" >RIV/70883521:28110/17:63516063 - isvavai.cz</a>

Výsledek na webu

<a href="http://dx.doi.org/10.1051/matecconf/201712103013" target="_blank" >http://dx.doi.org/10.1051/matecconf/201712103013</a>

DOI - Digital Object Identifier

<a href="http://dx.doi.org/10.1051/matecconf/201712103013" target="_blank" >10.1051/matecconf/201712103013</a>

Jazyk výsledku

angličtina

Název v původním jazyce

Creating and evaluating replicas of surfaces machined by laser beam

Popis výsledku v původním jazyce

In industrial practice, we often encounter a problem when it is necessary to measure and subsequently evaluate the surface quality of the part produced by the water jet, laser cutting. In that case, it is very often difficult to evaluate the final surface because of its weight or bulkiness. However, the literature sources recommend using of material known under the commercial name Dentacryl™. Although this material is still being used in technical practice, its utilisation for creating the replicas of the polypropylene surfaces which is produced by the laser beam is not recommended due to its limited viscosity and mainly due to its health risk for allergic people. Therefore, this article will describe a method of an application the two-component dental material Siloflex© for the creation of the replicas of polypropylene surfaces formed after CO2 laser machining. Furthermore, the statistical approach for evaluation of the quality comparison of the original surfaces and produced replicas is necessary to surface quality of produced replicas.

Název v anglickém jazyce

Creating and evaluating replicas of surfaces machined by laser beam

Popis výsledku anglicky

In industrial practice, we often encounter a problem when it is necessary to measure and subsequently evaluate the surface quality of the part produced by the water jet, laser cutting. In that case, it is very often difficult to evaluate the final surface because of its weight or bulkiness. However, the literature sources recommend using of material known under the commercial name Dentacryl™. Although this material is still being used in technical practice, its utilisation for creating the replicas of the polypropylene surfaces which is produced by the laser beam is not recommended due to its limited viscosity and mainly due to its health risk for allergic people. Therefore, this article will describe a method of an application the two-component dental material Siloflex© for the creation of the replicas of polypropylene surfaces formed after CO2 laser machining. Furthermore, the statistical approach for evaluation of the quality comparison of the original surfaces and produced replicas is necessary to surface quality of produced replicas.

Druh

D - Stať ve sborníku

CEP obor

—

OECD FORD obor

20301 - Mechanical engineering

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2017

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název statě ve sborníku

MATEC Web of Conferences

ISBN

—

ISSN

2261-236X

e-ISSN

neuvedeno

Počet stran výsledku

6

Strana od-do

—

Název nakladatele

EDP Sciences

Místo vydání

Les Ulis

Místo konání akce

Sibiu

Datum konání akce

7. 6. 2017

Typ akce podle státní příslušnosti

EUR - Evropská akce

Kód UT WoS článku

—