Percentage ratios of cutting forces during high-reed face milling

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F70883521%3A28110%2F23%3A63564918" target="_blank" >RIV/70883521:28110/23:63564918 - isvavai.cz</a>

Výsledek na webu

<a href="https://www.mdpi.com/1996-1944/16/1/384" target="_blank" >https://www.mdpi.com/1996-1944/16/1/384</a>

DOI - Digital Object Identifier

<a href="http://dx.doi.org/10.3390/ma16010384" target="_blank" >10.3390/ma16010384</a>

Jazyk výsledku

angličtina

Název v původním jazyce

Percentage ratios of cutting forces during high-reed face milling

Popis výsledku v původním jazyce

This research paper is concerned with the experimental study of high-feed end milling of 1.4541 (X6CrNiTi18-10) stainless steel with replaceable cermet plates. Several machining operations were performed under different cutting conditions. The variable values were depth of cut, feed per tooth and cutting speed. The results were analyzed, and cutting forces were evaluated for dependence on cutting conditions (cutting speed, depth of cut, feed per tooth). The obtained data were statistically processed and plotted in graphs. It was found that the percentage distribution of cutting forces changed as the tool load increased. The ratio of forces acting in individual axes also changed with varying trends. An increasing trend was recorded in the x and y axes, while a decreasing trend was recorded in the z axis. Measured change, approximately 10%, can no longer be neglected as it can significantly influence the clamping stability of a part.

Název v anglickém jazyce

Percentage ratios of cutting forces during high-reed face milling

Popis výsledku anglicky

This research paper is concerned with the experimental study of high-feed end milling of 1.4541 (X6CrNiTi18-10) stainless steel with replaceable cermet plates. Several machining operations were performed under different cutting conditions. The variable values were depth of cut, feed per tooth and cutting speed. The results were analyzed, and cutting forces were evaluated for dependence on cutting conditions (cutting speed, depth of cut, feed per tooth). The obtained data were statistically processed and plotted in graphs. It was found that the percentage distribution of cutting forces changed as the tool load increased. The ratio of forces acting in individual axes also changed with varying trends. An increasing trend was recorded in the x and y axes, while a decreasing trend was recorded in the z axis. Measured change, approximately 10%, can no longer be neglected as it can significantly influence the clamping stability of a part.

Druh

J_imp - Článek v periodiku v databázi Web of Science

CEP obor

—

OECD FORD obor

20301 - Mechanical engineering

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2023

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Materials

ISSN

1996-1944

e-ISSN

—

Svazek periodika

16

Číslo periodika v rámci svazku

1

Stát vydavatele periodika

CH - Švýcarská konfederace

Počet stran výsledku

13

Strana od-do

—

Kód UT WoS článku

000909832000001

EID výsledku v databázi Scopus

2-s2.0-85145782882