Vše

Co hledáte?

Vše
Projekty
Výsledky výzkumu
Subjekty

Rychlé hledání

  • Projekty podpořené TA ČR
  • Významné projekty
  • Projekty s nejvyšší státní podporou
  • Aktuálně běžící projekty

Chytré vyhledávání

  • Takto najdu konkrétní +slovo
  • Takto z výsledků -slovo zcela vynechám
  • “Takto můžu najít celou frázi”

Analýza kolísání podtlaku v dojicí jednotce

Identifikátory výsledku

  • Kód výsledku v IS VaVaI

    <a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F00027031%3A_____%2F05%3A8P012159" target="_blank" >RIV/00027031:_____/05:8P012159 - isvavai.cz</a>

  • Výsledek na webu

  • DOI - Digital Object Identifier

Alternativní jazyky

  • Jazyk výsledku

    angličtina

  • Název v původním jazyce

    Analysis of vacuum fluctuation in milking units

  • Popis výsledku v původním jazyce

    For the vacuum conditions measurement of the clusters the vacuum sensors, placed on 4 points of this clusters were used. Evaluated was the vacuum course in the liner chamber and in the claw in total pulse time in maximum and minimum phase by ISO 6690. The measurement was carried out under laboratory conditions and measured values were recorded. Evaluated were 5 different serial produced clusters with the claw volume of 150, 200, 300, 420, 450 and 500 cm3. By the flow- rate of 5 l.min-1 the vacuum decrease in the liner chamber of the clusters was 1.4 x3.3 kPa and in the claw 1.7 x5.3 kPa by the claw type. By the flow rate of 12 l.min-1 vacuum decrease in the liner chamber of the clusters was 4.1 x11.2 kPa and in the claw 3.9 x11.6 kPa. For total pulse time no evidential difference was found in comparison with the vacuum fluctuation evaluated only for maximum phase. The measurements will continue by measuring in the milking parlour during the real milking

  • Název v anglickém jazyce

    Analysis of vacuum fluctuation in milking units

  • Popis výsledku anglicky

    For the vacuum conditions measurement of the clusters the vacuum sensors, placed on 4 points of this clusters were used. Evaluated was the vacuum course in the liner chamber and in the claw in total pulse time in maximum and minimum phase by ISO 6690. The measurement was carried out under laboratory conditions and measured values were recorded. Evaluated were 5 different serial produced clusters with the claw volume of 150, 200, 300, 420, 450 and 500 cm3. By the flow- rate of 5 l.min-1 the vacuum decrease in the liner chamber of the clusters was 1.4 x3.3 kPa and in the claw 1.7 x5.3 kPa by the claw type. By the flow rate of 12 l.min-1 vacuum decrease in the liner chamber of the clusters was 4.1 x11.2 kPa and in the claw 3.9 x11.6 kPa. For total pulse time no evidential difference was found in comparison with the vacuum fluctuation evaluated only for maximum phase. The measurements will continue by measuring in the milking parlour during the real milking

Klasifikace

  • Druh

    J<sub>x</sub> - Nezařazeno - Článek v odborném periodiku (Jimp, Jsc a Jost)

  • CEP obor

    GB - Zemědělské stroje a stavby

  • OECD FORD obor

Návaznosti výsledku

  • Projekt

  • Návaznosti

    Z - Vyzkumny zamer (s odkazem do CEZ)

Ostatní

  • Rok uplatnění

    2005

  • Kód důvěrnosti údajů

    S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Údaje specifické pro druh výsledku

  • Název periodika

    ICAR Technical Series

  • ISSN

    1563-2504

  • e-ISSN

  • Svazek periodika

    Neuveden

  • Číslo periodika v rámci svazku

    10

  • Stát vydavatele periodika

    IT - Italská republika

  • Počet stran výsledku

    6

  • Strana od-do

    307-312

  • Kód UT WoS článku

  • EID výsledku v databázi Scopus