Solderability Dependence on Surface Roughness

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F49777513%3A23220%2F09%3A00504873" target="_blank" >RIV/49777513:23220/09:00504873 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Solderability Dependence on Surface Roughness

Popis výsledku v původním jazyce

The article deals with results of solderability testing of printed circuit boards. The wetting balance test was used for solderability testing. This test makes wetting force measurement possible as a function of time. Measured values are recorded automatically. Surface roughness is one of parameters, which influence surface wetting. The article will present the results and comparison of tested printed circuit boards with different surface roughness. Differences were in levels of roughness and orientation of scratches. This comparison will be made for testing samples of printed circuit boards with surface pure copper (Cu). The test samples were purposely roughened by different abrasive paper before solderability testing. Roughness made on surface finishes was oriented vertically and horizontally. These orientations are relative to attachment tested sample in tester.

Název v anglickém jazyce

Solderability Dependence on Surface Roughness

Popis výsledku anglicky

The article deals with results of solderability testing of printed circuit boards. The wetting balance test was used for solderability testing. This test makes wetting force measurement possible as a function of time. Measured values are recorded automatically. Surface roughness is one of parameters, which influence surface wetting. The article will present the results and comparison of tested printed circuit boards with different surface roughness. Differences were in levels of roughness and orientation of scratches. This comparison will be made for testing samples of printed circuit boards with surface pure copper (Cu). The test samples were purposely roughened by different abrasive paper before solderability testing. Roughness made on surface finishes was oriented vertically and horizontally. These orientations are relative to attachment tested sample in tester.

Druh

O - Ostatní výsledky

CEP obor

JA - Elektronika a optoelektronika, elektrotechnika

OECD FORD obor

—

Projekt

—

Návaznosti

Z - Vyzkumny zamer (s odkazem do CEZ)

Rok uplatnění

2009

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů