The suitability of microwave heating from the perspective of practical use in construction and building industry

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F60460709%3A41320%2F14%3A63972" target="_blank" >RIV/60460709:41320/14:63972 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

The suitability of microwave heating from the perspective of practical use in construction and building industry

Popis výsledku v původním jazyce

This paper reports on the total deformation and maximum deflection after microwave heating of beech wood. There have been few studies devoted to the examination of microwave heating for of beech wood. The same procedures can be used for structural materials in construction industry. Total deformation and maximum deflection were investigated on beech samples immediately after microwave heating. The samples were loaded parallel to the grain during compression and perpendicular to the grain during bending.Heating time and moisture content are important factors that affect the total deformation as well as maximum deflection. In general, heating time had negative influence to total deformation and maximum deflection. On the other hand the initial moisturecontent had a positive impact.

Název v anglickém jazyce

The suitability of microwave heating from the perspective of practical use in construction and building industry

Popis výsledku anglicky

This paper reports on the total deformation and maximum deflection after microwave heating of beech wood. There have been few studies devoted to the examination of microwave heating for of beech wood. The same procedures can be used for structural materials in construction industry. Total deformation and maximum deflection were investigated on beech samples immediately after microwave heating. The samples were loaded parallel to the grain during compression and perpendicular to the grain during bending.Heating time and moisture content are important factors that affect the total deformation as well as maximum deflection. In general, heating time had negative influence to total deformation and maximum deflection. On the other hand the initial moisturecontent had a positive impact.

Druh

J_x - Nezařazeno - Článek v odborném periodiku (Jimp, Jsc a Jost)

CEP obor

JP - Průmyslové procesy a zpracování

OECD FORD obor

—

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2014

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Wood Research

ISSN

1336-4561

e-ISSN

—

Svazek periodika

59

Číslo periodika v rámci svazku

3

Stát vydavatele periodika

SK - Slovenská republika

Počet stran výsledku

10

Strana od-do

401-410

Kód UT WoS článku

—

EID výsledku v databázi Scopus

—