Impact of angle geometry of tool on granulometric composition of particles during the flat milling of thermally modified beech

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F60460709%3A41320%2F15%3A66873" target="_blank" >RIV/60460709:41320/15:66873 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Impact of angle geometry of tool on granulometric composition of particles during the flat milling of thermally modified beech

Popis výsledku v původním jazyce

This paper deals with particle size analysis of beech wood, considering angular tool (mill) speed and also physical and mechanical wood properties substantially influencing wood processing technology. Particle size analysis was made by sieving the samples using a set of laboratory sieves, with subsequent determination of the individual fraction shares. The results have been compared with respect to the possibility of wood waste separation and filtration, and its subsequent utilization, above all, in production of agglomerated materials and production of wood briquettes and pellets. By the granulometric analysis there are detected changes in granulometric composition of the particles from thermo beech. The most frequently occurring fractions in native beech samples were ranging 8 - 5 mm and 5 - 2 mm, while powder fractions below 125 ?m were found less than 1% in investigated samples. The most frequently occurring fractions in thermally modified beech wood were ranging 1 ? 0.5 mm, share

Název v anglickém jazyce

Impact of angle geometry of tool on granulometric composition of particles during the flat milling of thermally modified beech

Popis výsledku anglicky

This paper deals with particle size analysis of beech wood, considering angular tool (mill) speed and also physical and mechanical wood properties substantially influencing wood processing technology. Particle size analysis was made by sieving the samples using a set of laboratory sieves, with subsequent determination of the individual fraction shares. The results have been compared with respect to the possibility of wood waste separation and filtration, and its subsequent utilization, above all, in production of agglomerated materials and production of wood briquettes and pellets. By the granulometric analysis there are detected changes in granulometric composition of the particles from thermo beech. The most frequently occurring fractions in native beech samples were ranging 8 - 5 mm and 5 - 2 mm, while powder fractions below 125 ?m were found less than 1% in investigated samples. The most frequently occurring fractions in thermally modified beech wood were ranging 1 ? 0.5 mm, share

Druh

J_x - Nezařazeno - Článek v odborném periodiku (Jimp, Jsc a Jost)

CEP obor

JJ - Ostatní materiály

OECD FORD obor

—

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2015

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Wood Research

ISSN

1336-4561

e-ISSN

—

Svazek periodika

60

Číslo periodika v rámci svazku

1

Stát vydavatele periodika

SK - Slovenská republika

Počet stran výsledku

10

Strana od-do

137-146

Kód UT WoS článku

000350927800013

EID výsledku v databázi Scopus

—