Statistical Comparison of Original and Replicated Surfaces

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F70883521%3A28110%2F19%3A63523650" target="_blank" >RIV/70883521:28110/19:63523650 - isvavai.cz</a>

Výsledek na webu

<a href="http://dx.doi.org/10.1007/978-3-030-18682-1_1" target="_blank" >http://dx.doi.org/10.1007/978-3-030-18682-1_1</a>

DOI - Digital Object Identifier

<a href="http://dx.doi.org/10.1007/978-3-030-18682-1_1" target="_blank" >10.1007/978-3-030-18682-1_1</a>

Jazyk výsledku

angličtina

Název v původním jazyce

Statistical Comparison of Original and Replicated Surfaces

Popis výsledku v původním jazyce

This article is focused on the statistical comparison of the original and replicated surface. Surface replication has been used for a long time, but recently a material with the commercial name Dentacryl (TM) has been used for the replication. However, this material has some disadvantages that outweigh the benefits. The article focuses on the use of Siloflex(C) dental impression material that is very sensitive to the detailed control. It also uses the non-contacting profile of Talysurf CLI 500, where initial parameters of the roughness (Ra, Rz, Rp, Rv and Rt) were recorded both on the original surface and on the replicated surface. These parameters are then compared using statistical methods such as K- means Clustering, PCA, and Factor Analysis.

Název v anglickém jazyce

Statistical Comparison of Original and Replicated Surfaces

Popis výsledku anglicky

This article is focused on the statistical comparison of the original and replicated surface. Surface replication has been used for a long time, but recently a material with the commercial name Dentacryl (TM) has been used for the replication. However, this material has some disadvantages that outweigh the benefits. The article focuses on the use of Siloflex(C) dental impression material that is very sensitive to the detailed control. It also uses the non-contacting profile of Talysurf CLI 500, where initial parameters of the roughness (Ra, Rz, Rp, Rv and Rt) were recorded both on the original surface and on the replicated surface. These parameters are then compared using statistical methods such as K- means Clustering, PCA, and Factor Analysis.

Druh

D - Stať ve sborníku

CEP obor

—

OECD FORD obor

20301 - Mechanical engineering

Projekt

—

Návaznosti

V - Vyzkumna aktivita podporovana z jinych verejnych zdroju

Rok uplatnění

2019

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název statě ve sborníku

Advances in Manufacturing II, Vol 5 - Metrology and Measurement Systems

ISBN

978-3-030-18682-1

ISSN

2195-4356

e-ISSN

—

Počet stran výsledku

10

Strana od-do

1-10

Název nakladatele

Springer Verlag

Místo vydání

Berlín

Místo konání akce

Poznaň

Datum konání akce

19. 5. 2019

Typ akce podle státní příslušnosti

WRD - Celosvětová akce

Kód UT WoS článku

000490714000001